TinkerCAD Lesson 5

TinkerCAD Design 2:


To create this shape I had to:

1. I created the crown today
2. I went on the geometric section and searched for the pink half sphere
3. I sized it to a length of 99mm, width of 94mm and height of 40mm
4. Then I clicked the half sphere but sized it to a width of 9.86.mm and length of 97.40mm and height of 48.31mm
5. I placed that in the middle of the half sphere and on the side of the sphere
6. Then I clicked on star shape and sized it to  length of 15.00mm and width of 14.27mm and height of 4.00mm, I placed it in the middle of the red sphere
7. Then I clicked on the blue diamond and placed it on the left side of the sphere
8. I copied and pasted the diamonds on all the sides
9. Finally I changed the color of the shapes to suit my personality

Reflection: 

I chose this design because I found it really interesting and colorful  as well as it didn't look so complicated. The design wasn't really like this, it was left colorful and more complicated, I changed it a bit but I think it turned out just fine. I actually think it looks better, to be honest. This is a more childish version of the crown, and it would be targeted to children. If I had to do this again, I would do a more complicated version and add more detail and more decorations. I liked to do this design and so far, creating the crown was my favourite part.